ACE_TTY_IO::Serial_Params Struct Reference

#include <TTY_IO.h>

List of all members.

Public Member Functions

 Serial_Params (void)

Public Attributes

int baudrate
int xonlim
int xofflim
unsigned int readmincharacters
int readtimeoutmsec
const char * paritymode
bool ctsenb
unsigned char rtsenb
bool xinenb
bool xoutenb
bool modem
bool rcvenb
bool dsrenb
bool dtrdisable
unsigned char databits
unsigned char stopbits

Constructor & Destructor Documentation

ACE_TTY_IO::Serial_Params::Serial_Params ( void   ) 

Member Data Documentation

Specifies the baudrate at which the communnication port operates.

Enable & set CTS mode. Note that RTS & CTS are enabled/disabled together on some systems (RTS/CTS is enabled if either ctsenb or rtsenb is set).

Data bits. Valid values 5, 6, 7 and 8 data bits. Additionally Win32 supports 4 data bits.

Controls whether DSR is disabled or enabled (Win32).

Controls whether DTR is disabled or enabled.

Specifies if device is a modem (POSIX). If not set modem status lines are ignored.

Specifies the parity mode. POSIX supports "none", "even" and "odd" parity. Additionally Win32 supports "mark" and "space" parity modes.

Enable/disable receiver (POSIX).

Specifies the minimum number of characters for non-canonical read (POSIX).

Specifies the time to wait before returning from read. Negative value means infinite timeout.

Enable & set RTS mode. Note that RTS & CTS are enabled/disabled together on some systems (RTS/CTS is enabled if either ctsenb or rtsenb is set).

  • 0 = Disable RTS.
  • 1 = Enable RTS.
  • 2 = Enable RTS flow-control handshaking (Win32).
  • 3 = Specifies that RTS line will be high if bytes are available for transmission. After transmission RTS will be low (Win32).

Stop bits. Valid values are 1 and 2.

Enable/disable software flow control on input.

Specifies the maximum number of bytes in input buffer before XOFF char is sent. Negative value indicates that default value should be used (Win32).

Specifies the minimum number of bytes in input buffer before XON char is sent. Negative value indicates that default value should be used (Win32).

Enable/disable software flow control on output.


The documentation for this struct was generated from the following files:
 All Classes Namespaces Files Functions Variables Typedefs Enumerations Enumerator Friends Defines

Generated on Fri Sep 11 03:58:55 2009 for ACE by  doxygen 1.6.1