The pluggable protocol framework uses the Acceptor and Connector patterns, unlike ACE, however, it must treat all of them homogenously. The basic abstraction in TAO's pluggable protocol framework is the
TAO_Transport, an instance of this class represents a single connection, for example, the IIOP plugin uses one instance of TAO_Transport for each socket. To integrate this abstraction with the ACE_Reactor framework, all the protocols implemented so far use specializations of the ACE_Svc_Handler class. However, the original design considered the possibility of using protocols without any ACE abstractions, though in practice this hasn't happenned so far, all changes to the framework should keep this possibility open.
This is the main source of memory management problems in the pluggable protocol framework: a single entity (a connection) is represented by two instances of two separate classes. On one side the ORB uses an instance of the TAO_Transport abstraction, on the other the Reactor uses an instance of an ACE_Svc_Handler.
To complicate matters even further the ORB caches both passively accepted and actively established connections. The actively established connections are cached by the client-side to minimize or amortize the cost of connection establishment. The passively accepted connections are kept in the same cache mainly to support bi-directional GIOP, however, they also allow us to close both accepted and established idle connections using a single component, this is useful when the ORB shutdowns, but it is crucial in the implementation of connection recycling strategies, where the total number of connections kept by the ORB must be known.
The design must also support multithreaded clients and servers, in both cases multiple threads may be using a connection simultaneously, for example, multiple client threads can be waiting for replys over the same connection, or multiple server threads can be servicing requests received on the same connection, or, if bi-dir GIOP is enabled, maybe a mix of both.
Some aspects of the GIOP protocol require special treatment of connections with pending requests, both on the server and client side. On the server side connections that have pending requests cannot be closed (section 184.108.40.206 in the CORBA/IIOP 2.4 specification), therefore, the ORB needs to know how many requests are pending, at all times. Despite this, it is possible that the underlying connection is broken, for example, because the client crashed. In such cases, the ORB should be able to reclaim the OS resources, but the TAO_Transport must remain valid until the upcall threads finish. Similarly, the client side should be able to distinguish between orderly and abortive disconnects, essentially the ORB needs to know if a
CloseConnection message has been received.
Finally we must never forget that the ORB can be used in thread-per-connection mode. In this concurrency model there is no reactor used to detect when the connection can accept more input, though normally this is a global setting, it is possible for a pluggable protocol to *always* work in thread-per-connection and no other architecture. Similarly, the ORB can be configured to wait for replys using read() operations, instead of the more generic wait-on-reactor or wait-on-leader-follower strategies. Therefore, we cannot always rely on the Reactor framework to perform all the memory management for us.
The underlying connection can be closed by the remote peer, in this case, either the Reactor or the thread blocked on
read() will detect the problem. Following the normal conventions, the ACE_Svc_Handler would be closed as soon as this is detected. The corresponding TAO_Transport must be informed, otherwise it could attempt to use a connection already closed.
Finally if the connection is proactively closed, the TAO_Transport informs the ACE_Svc_Handler, at this point the ACE_Svc_Handler commits suicide by removing itself from the reactor. Notice that it must still callback the TAO_Transport in this case.
A much simpler approach would be to read the data on the handle_input() method itself, and forward the data up the stream.